Reminiscent of a stripped down '48 Pan, we've assembled all the hard to find parts to build the 'Bobber' of your dreams! From the old-style floorboards to the classic springer front end, this bike's got cool written all over it? The "Pimp Daddy" Bike Kit comes complete with our brand-new 80c.i. "Pan" demonium engine, RevTech 4-speed kicker tranny and everything listed below. If you really wanna go custom, "Pimp Daddy" is available as a rolling chassis kit!

• 88c.i "Pan" Demonium engine and motor mounts. Complete with S&S Super "E" carb & Mallory Unlite distributer.
• Revteck 4-speed kickstart tranny.
• Straight leg style rigid frame with Fat Bob tank mounts for chain rear drive. 2" stretch in down-tubes and 33 degree rake. (includes frame cups and heavy-duty bearings).
• Old style oval floorboards with weld-on tabs and brackets.
• Heavy-Duty Kickstand and bracket.
• FXST style shifter/brake kits with chrome rear master cylinder.
• 12V Bottom mount 6 1/2 inch headlight assembly with lowering block.
• Stock length Springer with axle kit an fender.
• GMA billet dual-action front brake caliper, support bracket and mounting hardware.
• White Bros. 36" wide Bikini Beach Bars with 3" vintage risers, dual cable throttle assembly and vintage grips.
• 21" chromed 40 spoke front wheel (single flange) wtih 90/90H X 21" Avon "Venom-X" whitewall tire, rim strip and tube.
• 16" chromed 40 spoke rear wheel (dual flange) with 130/90HB X 16" Avon "Venom-X" whitewall tire, rim strip, and rear axle kit.
• Motor Factory chromed 3 1/2 quart side-fill hex wrap-around oil tank.
• 3.5 gallon Fat Bob style gas tanks for screw-in type gas caps
• Chrome cateye dash kit complete with 1:1 ratio white-face speedo, mounting kit and ignition switch.
• 6" flat rear fender with chromed fender brace and 50's style taillight.
•Assorted Hardware.